Is your toilet constantly overflowing? Don’t know how to fix it?
Toilets are an integral part of our daily lives that we take as a given. They are crucial, but only when they stop working do we realize how important they really are. If they become too full, it can lead to panic attacks and you may not know what next.
Don’t worry! Keep reading to learn what you can do if your toilet is constantly overflowing.
How to get started immediately
These are the things that you should do as soon as the situation occurs to stabilize it.
Turn off the water
You should turn off your water if your toilet is leaking and doesn’t show signs of stopping. Even if your toilet overflows, this should be your first action.
A shutoff valve is a common feature on most toilet water supply lines. It should be located under the toilet tank, near the floor.
Get rid of all standing water and waste
To remove any standing water and waste, it is best to use a dry-wet vacuum. You can rent one from most rental shops if you don’t own one.
To absorb the water, you can also use blankets and towels. You will need to wash them thoroughly if you plan to reuse them. You will likely have to dispose of them if there is a lot of waste.
Clean the area
After removing all standing water and waste, clean the bathroom from top to bottom using soap and warm water. Next, use a bleach mixture to disinfect the area. It is best to use a bleach mixture of one cup and one-gallon water. It will kill bacteria and mold, as well as remove bad odors.
DIY Fixes
After you have dealt with the immediate problem, it is time to determine the root cause. It could be for a number of reasons, so let’s take a look at these solutions:
Give it a try
If it’s not a problem with the water mains, you might have a blockage. First, get your plunger. A plunger with a flange at the bottom is best. It will reach into the drain hole, making it a better seal and allowing for a more efficient plunge.
It is not the size of your plunger that matters, but how you use it. For between 15 and 20 seconds, keep the handle straight. This part requires some effort to achieve the best results.
This “plunging” action forces water and air into the drain. The clog will then be broken down and encouraged to go away. To ensure that the pipes are clear, flush your toilet.
A plunger can be purchased at any hardware or home improvement store. If you are stuck in a sticky situation, there are ways to unclog your toilet without a plunger.
Use a Snake
If the plunger isn’t working, you can use a toilet snake. This flexible cable will help you navigate the twists of the toilet drain.
Use rubber gloves to dry the bowl. Turn the crank to extend your line further. You’ll reach the clog by stopping cranking it when it stops going further.
This will require delicate handling. If you feel resistance, pull back on the snake. Then, you can pull the snake back through the drain to the bowl.
You can place any clogged material into a bucket. Keep doing this until it is all gone. For safety, flush the toilet. The clogged material can be put back in the toilet by flushing it each time. This ensures that the toilet doesn’t overflow again.
This post was written by Joey Denick. Joey is the Owner and Operator of Clog Kings. At Clog Kings, LLC, we pride ourselves on our dedication and efficiency. We know you don’t have time to waste. That’s why we work fast to get your home or commercial building back up and running in no time. If you are looking for drain cleaning in Tampa then look no further because we got you covered!